-
Notifications
You must be signed in to change notification settings - Fork 2
Runtime Options
uriba107 edited this page Sep 18, 2017
·
1 revision
The TQS code allows the user some calibration options via the use of "config mode".
To enter "Config Mode" press and hold Uncage and Speedbreaks open for 2 seconds.
Once enabled Config Mode will remain enabled for 20 seconds or until you select an options.
Available options:
| Button | Action |
|---|---|
| UHF | Exit Config Mode immidiatly (and save) |
| VHF | center Microstick (and exit config mode) |
| IFF IN | Save Current position of roteries as center (Detent calibration) |
| IFF OUT | drop all current Min/Max values for microstick and throttle. Then, while in config mode, update Min/Max Values (20 seconds or UHF is pushed) |
an addition special mode is available to boot TQS controller to bootloader to allow device firmware to be updated. to enter boot loader press and hold the following buttons for 5 seconds: Uncage, Cursor Enable, Speedbreaks Open.