Tunning and using a receiver module

Scanning for FM stations

To automatically scan stations, press UP or DOWN buttons in the receiver module. At the auto-scanning, this module increases/decreases the tuner frequency with 25kHz steps. This auto-scanning continues until the tuner detects a strong FM radio station.

Changing the volume level

To adjust the output volume, press + or - buttons in the receiver module.

Store FM station in memory

This receiver module got ten station program memory. To store the FM stations in program memory, follow the steps below:

1. Tune the receiver to the desired station using the UP or DOWN buttons.
2. Press the MEM button to open the memory manager.
3. Select the memory slot using the UP or DOWN buttons. In memory manager mode, the seven-segment display indicates the memory slot number with the prefix S.
4. Press + button to save the station.

Loading a programmed stations

To recall the programmed FM station, follow the steps below:

1. Press the MEM button to open the memory manager.
2. Select the memory slot using the UP or DOWN buttons. In memory manager mode, the seven-segment display indicates the memory slot number with the prefix S.
3. Press - button to load the FM station from the selected memory slot.
4. If the selected slot is empty, the receiver module got tunes to the lower limit of the FM band.