grblAlarm.py

# -*- coding: UTF-8 -*-

'''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''
'                                                                         '
' Copyright 2018 Gauthier Brière (gauthier.briere "at" gmail.com)         '
'                                                                         '
' This file is part of cn5X++                                               '
'                                                                         '
' cn5X++ is free software: you can redistribute it and/or modify it         '
'  under the terms of the GNU General Public License as published by      '
' the Free Software Foundation, either version 3 of the License, or       '
' (at your option) any later version.                                     '
'                                                                         '
' cn5X++ is distributed in the hope that it will be useful, but           '
' WITHOUT ANY WARRANTY; without even the implied warranty of              '
' MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE.  See the           '
' GNU General Public License for more details.                            '
'                                                                         '
' You should have received a copy of the GNU General Public License       '
' along with this program.  If not, see <http://www.gnu.org/licenses/>.   '
'                                                                         '
'''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''

grblAlarm = [
  [0, "No Alarm."],
  [1 ,"Hard limit","Hard limit has been triggered. Machine position is likely lost due to sudden halt. Re-homing is highly recommended."],
  [2 ,"Soft limit","Soft limit alarm. G-code motion target exceeds machine travel. Machine position retained. Alarm may be safely unlocked."],
  [3 ,"Abort during cycle","Reset while in motion. Machine position is likely lost due to sudden halt. Re-homing is highly recommended."],
  [4 ,"Probe fail","Probe fail. Probe is not in the expected initial state before starting probe cycle when G38.2 and G38.3 is not triggered and G38.4 and G38.5 is triggered."],
  [5 ,"Probe fail","Probe fail. Probe did not contact the workpiece within the programmed travel for G38.2 and G38.4."],
  [6 ,"Homing fail","Homing fail. The active homing cycle was reset."],
  [7 ,"Homing fail","Homing fail. Safety door was opened during homing cycle."],
  [8 ,"Homing fail","Homing fail. Pull off travel failed to clear limit switch. Try increasing pull-off setting or check wiring."],
  [9 ,"Homing fail","Homing fail. Could not find limit switch within search distances. Try increasing max travel, decreasing pull-off distance, or check wiring."]
]