3D20-Marlin profiles for Cura / Super Slicer, etc?

[bbatchelder]

Hey folks, I'm curious if anyone has put together slicer profiles for the 3D20 with Marlin firmware loaded?

I've got one started for Cura, based on the 3D20 plugin from Tim (https://github.com/timmehtimmeh/Cura-Dremel-Printer-Plugin)

The biggest change so far being the Start G-code (see wiki warning about not using original flashforge g-code (https://github.com/moonglow/FlashForge_Marlin/wiki/%5BATTENTION%5D-Avoid-using-FlashForge-original-firmware-G-Codes)

[moonglow]

Hi !

My main slicer is Cura for my FF Dreamer NX and it works fine for me. Btw with Marlin we can use many other Slicers too with really simple setup.

[geeeethub]

@bbatchelder would you be interested in posting your profiles for Cura for the 3D20 w/ Marlin?

[bbatchelder]

Absolutely, I just need to clean them up a bit, I did a lot of experimenting coming from Simplify3D and trying to find equivalent settings in Cura.

[bbatchelder]

Finally got them to a point I think they're worth sharing....

https://github.com/bbatchelder/cura-dremel-3d20marlin

[ShinNinth]

Hey are you still possibly sharing this Cura config? I am not sure other that the M907 code what i should be looking out for for my 3d20 in cura now that I've put marlin on it

[bbatchelder]

Hey there - yeah, just threw them in a repo: https://github.com/bbatchelder/cura-dremel-3d20marlin

[ShinNinth]

Thank you I appreciate it!