I'm using version 1.14.0-dev in a hassio.
The configurations are modular. Each device will have a single yaml file, this file will use a device specific file from the templatefiles directory.
The device specific file will then import the common settings from either
- common.yaml (THIS USES DHCP)
- common_static.yaml (THIS USES STATIC IP)
The common files will pull the secrets from templatefiles/secrets.yaml
Each Device has the following standard sensors:
- MAC address
- Uptime
- Version
- Wifi Signal (in dB)
- Wifi Strength (in english)
Each Device also has the following switch:
- Restart
-
Room Sensor DHT11
This is a NodeMcu with a DHT11 connected to Pin D2. The temperature and humidity values are averaged to reduce erroreous spikes in values.
-
Room Sensor bmp280
This is a Wemos-D1 mini with a hw-611 e/p (bmp280) connected D1/sda D2/scl.
-
Room Sensor (esp32)
This is a Nodemcu-esp32 with a DHT11 connected to GPIO15. The temperature and humidity values are averaged to reduce erroreous spikes in values.
-
espcam32
This is an AIThinker esp32cam board available from AliExpress I have installed heatsinks on the esp32 chip, as I found that the camera would stop working after a few minutes/hours.
The Flash is presented as a switch.
-
SonOff POW R1
This is a SonOff POW R1
-
SonOff POW R2
This is a SonOff POW R2