Add est. weight of cart + instrument, reference to detailed shutdown …

…procedure.

handling/telescope_install.rst

@@ -16,7 +16,10 @@ Initial Conditions
 Preparations
 ------------
 
--  Shutdown MagAO-X
+-  If operating, shut down MagAO-X.
+
+   - Make sure to leave stages/wheels in positions that are safe for transportation
+   - Complete procedure in the :ref:`telescope removal procedure <tel_remove_shutdown>`
 
 -  Prepare Legs for Move
 
@@ -157,7 +160,7 @@ Rig Onto Cart
 
 -  Position two people to remove the legs from under the table
 
--  Begin SLOWLY lifting the table off the legs.
+-  Begin SLOWLY lifting the table off the legs. Once table is fully supported by the crane, the scale will read around 2000 lbs (as of March 2024).
 
 -  Go up 0.5inch then stop and inspect the platters.  Use a long flathead screwdriver to very gently pry any stuck platters off bottom of table.
 

handling/telescope_removal.rst

@@ -13,14 +13,16 @@ Initial Conditions
 
 -  Instrument on Magellan Clay Nasmyth Platform, operating.
 
+.. _tel_remove_shutdown::
+
 Shutdown
 ------------
 
 -  At the end of the last night, have the TO position the telescope so that the NASE platform faces the elevator.
 
 -  Power down all of MagAO-X
 
-   - Ensure that ``stagepickoff`` in the ``tel`` position.
+   - Ensure that ``stagepickoff`` is in the ``tel`` position.
    - Place the k-mirror at 0 degrees.
    - Select the Ha-narrow and CH4-875 filters on fwsci1/2
    - turn off power for all devices on MagAO-X following the regular shutdown procedure.
@@ -115,8 +117,8 @@ Rig Onto Cart
 -  Reposition the load spreader center to the instrument + cart
    position marked on it.
 
--  Install the triangle stabilizing ropes between the crane hook and
-   the lifting fixture IAW the below figure. Tighten, but do not cause
+-  Install the triangle stabilizing ropes between the crane hook and 
+   the lifting fixture in accordance with the below figure. Tighten, but do not cause
    them to pick the load.
 
    .. image:: figures/stabilizers.jpg