-
Notifications
You must be signed in to change notification settings - Fork 4
Board Hardware
Backside of the board can easily be removed by unscrewing the screws along the edge of the board, as well as three screws in the middle of the board. Make sure to also remove the main unit by loosening the two clips on each side and popping it out. This will expose the electronics of the board, as well as connectors for the batteries and button. /images/board.JPG /images/board_closeup.JPG
Batteries and button is connected to the board via connectors as seen below /images/connectors.JPG
Button contains of two red LEDs, two green LEDs, and a button /images/button_closeups.png
The button is screwed into the backside of the board with two small screws. Removing those makes it possible to pull the button out. You can then also push the whole blue cylinder with the button shell out on the frontside of the board /images/button_connector1.JPG