In dit hoofdstuk wordt uitgelegd hoe je via de ICSP (In Circuit Serial Programmer) een Arduino-achtige kunt programmeren. De tekst is verder uitsluitend in het Engels.
In this chapter is explained how to program an Arduino like chip through ICSP (In Circuit Serial Programmer).
- First buy(can be found for less than € 1) and connect the USB ASP. Pay attention to the connection of the header with the ICSP connector on the PCB. Some USB ASP do not have a notch to indicate pin 1. Most of the time the flat cable has a red wire on pin 1. On the Arduino Uno there is a very very small white dot at pin 1.
In an Arduino Nano there is a small '1' at the rear of the board:
Source: my own pictures
Source https://tutorial.cytron.io/2015/02/05/using-avr-usbasp-program-arduino/
- Now install the correct driver using the Zadig tool. See.
-
Open the Arduino IDE and load an example program e.g. Blink.
-
Select the correct target board e.g. Arduino Uno:
- Select the correct programmer:
- Now upload your program through the special USB ASP with the menu 'Upload with programmer':
