The ICM-20608-G is the latest 6-axis device offered by InvenSense for the mass market. Compared to previous 6-axis devices, the ICM-20608-G offers lower power consumption, lower noise, and a thinner package. The ICM-20608-G offers a duty-cycled operation mode for the gyroscope, that reduces gyroscope power consumption by half or more (depending on ODR) compared to earlier 6-axis devices. It also provides about 20% lower noise than previous devices, and about 17% thinner package compared to previous devices.
The ICM-20608-G is a 6-axis MotionTracking device that combines a 3-axis gyroscope, and a 3-axis accelerometer in a small, 3 mm x 3 mm x 0.75 mm (16-pin LGA) package. It also features a 512-byte FIFO that can lower the traffic on the serial bus interface, and reduce power consumption by allowing the system processor to burst read sensor data, entering into a low-power mode. The ICM-20608-G, with its 6-axis integration, enables manufacturers to eliminate the costly and complex selection, qualification, and system level integration of discrete devices, guaranteeing optimal motion performance for consumers.
More information for this repo can be found on the Drotek.com product page
Use the image below to wire your card for I2C use.
[
Use the image below to wire your card for Hardware SPI.
[
- /Hardware - PDF design files
The hardware is released under Creative Commons Share-alike 4.0.