sms-telegram.yaml

# Datasheet https://github.com/Xinyuan-LilyGO/LilyGo-T-Call-SIM800
# Using SIM800C

esphome:
  name: sms-telegram

esp32:
  board: esp32dev

wifi:
  ssid: !secret wifi_ssid
  password: !secret wifi_password
  use_address: 10.0.0.11
  ap:
    password: !secret fallback_password

captive_portal:

logger:

api:

ota:

mqtt:
  broker: !secret mqtt_broker
  username: !secret mqtt_username
  password: !secret mqtt_password
  discovery: false  # Publish to MQTT, but not for Home Assistant (HA uses its own API)

uart:
  baud_rate: 9600
  tx_pin: 27
  rx_pin: 26

sim800l:
  on_sms_received:
    - lambda: |-
        id(sms_sender).publish_state(sender);
        id(sms_message).publish_state(message);
    - mqtt.publish_json:
        topic: sms-telegram/sms
        payload: |-
          root["from"] = sender;
          root["text"] = message;
  on_incoming_call:
    - lambda: |-
        id(caller_id_text_sensor).publish_state(caller_id);
    - mqtt.publish_json:
        topic: sms-telegram/call
        payload: |-
          root["from"] = caller_id;

binary_sensor:
  - platform: sim800l
    registered:
      name: "SIM800C Registered"

text_sensor:
  - platform: template
    id: sms_sender
    name: "SMS Sender"
  - platform: template
    id: sms_message
    name: "SMS Message"
  - platform: template
    id: caller_id_text_sensor
    name: "Caller ID"

switch:
  - platform: gpio
    name: "SIM800_POWER"
    pin: 25
    restore_mode: ALWAYS_ON

sensor:
  - platform: uptime
    name: "Uptime Sensor"
  - platform: wifi_signal
    name: "WiFi Signal Sensor"
  - platform: sim800l
    rssi:
      name: "Sim800C RSSI"