Home Assistant Reolink addon

The reolink implementation allows you to integrate your Reolink devices in Home Assistant.

You can configure the Reolink integration by going to the integrations page inside the configuration panel.

Installation

In your Home Assistant installation go to: Configuration > Integrations, click the button Add Integration > Reolink IP camera Enter the details for your camera. The camera will now be available as an entity.

For the motion detection to work, Home Assistant must be reachable via http from your local network. So when using https internally, motion detection will not work at this moment.

Services

The Reolink integration supports all default camera services and additionally provides the following services:

Service reolink.set_sensitivity

Set the motion detection sensitivity of the camera. Either all time schedule presets can be set at once, or a specific preset can be specified.

Service data attribute	Optional	Description
entity_id	no	The camera to control.
sensitivity	no	The sensitivity to set, a value between 1 (low sensitivity) and 50 (high sensitivity).
preset	yes	The time schedule preset to set. Presets can be found in the Web UI of the camera.

Service reolink.set_daynight

Set the day and night mode parameter of the camera.

Service data attribute	Optional	Description
entity_id	no	The camera to control.
mode	no	The day and night mode parameter supports the following values: AUTO Auto switch between black & white mode COLOR Always record videos in color mode BLACKANDWHITE Always record videos in black & white mode.

Service reolink.ptz_control

Control the PTZ (Pan Tilt Zoom) movement of the camera.

Service data attribute	Optional	Description
entity_id	no	The camera to control.
command	no	The command to execute. Possibe values are: AUTO, DOWN, FOCUSDEC, FOCUSINC, LEFT, LEFTDOWN, LEFTUP, RIGHT, RIGHTDOWN, RIGHTUP, STOP, TOPOS, UP, ZOOMDEC and ZOOMINC.
preset	yes	In case of the command TOPOS, pass the preset ID here. The possible presets are listed as attribute on the camera.
speed	yes	The speed at which the camera moves. Not applicable for the commands: STOP and AUTO.

The camera keeps moving until the `STOP` command is passed to the service.

Camera

This integration creates a camera entity, providing a live-stream configurable from the integrations page. In the options menu, the following parameters can be configured:

Parameter	Description
Stream	Switch between Sub or Main camera stream.
Protocol	Switch between the RTMP or RTSP streaming protocol.
Channel	When using a single camera, choose stream 0. When using a NVR, switch between the different camera streams.

Binary Sensor

When the camera supports motion detection events, a binary sensor is created for real-time motion detection. The time to switch motion detection off can be configured via the options menu, located at the integrations page. Please notice: for using the motion detection, your Homa Assistant should be reachable (within you local network) over http (not https).

Parameter	Description
Motion sensor off delay	Control how many seconds it takes (after the last motion detection) for the binary sensor to switch off.

Switch

Depending on the camera, the following switches are created:

This integration creates a camera entity, which can be configured from the integrations page. In the options menu, the following parameters can be configured:

Switch	Description
Email	Switch email alerts from the camera when motion is detected.
FTP	Switch FTP upload of photo and video when motion is detected.
IR lights	Switch the infrared lights to auto or off.
Record audio	Record auto or mute. This also implies the live-stream.
Recording	Switch recording to the SD card.

Unsupported models

The following models are not to be supported:

• E1
• E1 Pro
• Battery-powered cameras
• B800: Only with NVR
• B400: Only with NVR
• D400: Only with NVR