test_geometry.m

%%% Create Motor Geometry Struct %%%

g.depth =       8;      % axial length
g.s.slots =     36;     % stator slots
g.s.r1 =        40.5;     % tooth surface radius
g.s.r2 =        31.8;     % radius at tooth root
g.s.r3 =        29.3;     % backiron radius
g.s.t_pct =     .39;     % tooth fill percent
g.s.tip_pct =   .75      % tooth tip fill percent
g.s.tip_l =     1;      % Tooth tip length
g.s.tip_angle = pi/16;   % Tooth tip flare angle
g.s.ff =        .8;     % Slot fill-factor

g.r.ppairs =    21;      % pole-pairs
g.r.r1 =        40.7;     % rotor surface radius
g.r.r2 =        42.02;     % back-iron radius, magnet side
g.r.r3 =        43.42;     % backiron radius
g.r.m_pct =     .7;     % Magnet fill percent


g = calc_geometry(g);