3D printable wall-mountable holders for Microbit-Bits.
I got a Xiaomi WowStick 1F Pro. It was delivered with three tubes. Each of it has 20 Microbits for different screws. From my older Xiaoni WowStick 1 i had one more tube. The problem was, the Microbits fall out off the tubes because the cap was too loose. So i created this Microbit holder. You can mount it to the wall with a 4 mm screw. Alternative you can use 1 to 3 Neodym Magnets 20x3 mm on the backside.
The Microbit-holder consists of 1 part. There are two Versions. One for 60 parts, one more for 80 parts. The WowStick can be placed on top of the holder.
Requirements:
- 3D printer
- Filament of your choice
